- Rookie
MW significa poço LPV-100-12 Driver de LED 102W 12V IP67 Fonte de alimentação Impermeável, Modelo: LPV-100-12, loja
Design de tensão constante Suportar a entrada de 300
VAC por 5 segundos. Protections : curto -circuito / sobrecarga / over tensão. Totalmente encapsulado com o nível IP67. Adequado para aplicações de iluminação LED e sinal de movimento. Design de tensão constante. Suportar a entrada de 300
VAC por 5 segundos. Protections : curto -circuito / sobrecarga / over tensão. Totalmente encapsulado com o nível IP67. Adequado para aplicações de iluminação LED e sinal de movimento. Recursos : entrada constante de tensão de tensão UNIVERSAL DIVERSAL/RANÇA COMPLETA COM INSTRUÇÃO DE PERGURAS DE 300
VAC DE 5 SEGUNDOS PROTTEÇÕES : Curto -circuito/sobrecarga/over Voltage
Cooling por ar livre encapsulado com ar livre com IP67 IP67 Isolada LED LEDLA LUMPELAÇÃO PLÁSTICA EM FGCLASS 2 Unit
Passpasspasspuls Lps
Stable para luminária de plástico isolada APLICAÇÕES100% Custo de Testlow de Burn-In de carga total, alta confiabilidade Especificação : Modelo : LPV-100-12
DC Tensão : 12
VCurrent Faixa : 0 ~ 8.
Folha de dados
- MODEL:
- LPV-100-12
- DC VOLTAGE:
- 12V
- CURRENT RANGE:
- 0~8.5A
- RATED CURRENT:
- 8.5A
- RATED POWER:
- 102W
- RIPPLE&NOISE (max.):
- 120mVp-p
- VOLTAGE TOLERANCE:
- 5.0%
- LINE REGULATION:
- 1.0%
- LOAD REGULATION:
- 2.0%
- SETUP, RISE TIME:
- 2000ms, 25ms/230VAC 2000ms,25ms/115VAC
- HOLD UP TIME(Typ.):
- 50ms/230VAC 16ms/115VAC at full load
- VOLTAGE RANGE:
- 90~264VAC 127~370VDC
- FREQUENCY RANGE:
- 47~63Hz
- EFFICIENCY (Typ.):
- 84%
- AC CURRENT (Typ.):
- 2.2A/115VAC 1.2A/230VAC
- INRUSH CURRENT (Typ.):
- COLD START 30A/115VAC 60A/230VAC
- LEAKAGE CURRENT:
- 0.25mA/240VAC
- OVER CURRENT:
- 110~150% rated output power
- OVER VOLTAGE:
- 13.8~16.2V
- NOTE:
- 1.All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature:
- 2.Ripple & noise are measured at 20MHz of bandwidth by using a 12 twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor:
- 3.Tolerance :
- includes set up tolerance, line regulation and load regulation
- 4.Derating may be needed under low input voltage. Please check the static characteristics for more details:
- 5.The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again:
- 6.Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time :